Drgem X Ray Service | Manual

⚠️ Do not perform tube warm-up if the system shows “low oil level” or “rotor stall.” Permanent tube damage may result.

| Error Code | Description | Likely Root Cause | Service Action (per manual) | | :--- | :--- | :--- | :--- | | | Filament Preheating Fail | Broken filament or filament driver fault | Measure tube filament resistance. Check driver board F1 fuse. | | E-204 | Rotor Stalling | Damaged stator windings or bearing seizure | Run rotor test mode. Check stator continuity (approx 20-40 ohms). | | E-307 | AEC Ion Chamber Timeout | Defective chamber or exposure termination logic | Test with non-AEC technique. If resolved, replace AEC board. | | E-415 | Detector Communication Lost | WiFi interference or Ethernet cable failure | Ping detector IP (default 192.168.10.50). Re-pair wireless. | | W-501 | Tube Overload (Thermal) | Excessive heat unit accumulation | Allow cooling. Check anode thermal sensor calibration. | drgem x ray service manual